T30 quick pulling with 100ft storage box
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
NNEP duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
BS-30 Indoor type movable rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
|
FYG-300/400/500 Split type hydraulic crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
preformed dead end grip for cables |
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique desi... |
|
|
4.5mm x 50' Duct Rodder Fish Tape |
1. The model steel and wire one-piece fusion, more wear-resisting, safe load of 300 kg。 2. Spring steel wire head, can rotate 360 degrees, can be b... |
供应产品
Same products