W0850T fish type obdurability
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
JYJ-400A confining pressure of 16-400 square millimeter |
Manual type crimping pliers:Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
AF-15 producer Glass fiber reinforced plastic cleaning rod |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
AF-15 high quality cobra snake continuous fiberglass |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
SKL-4 Aluminum alloy cable grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
3T,5T ,8T,10T,12T Payload Cable Drum Trailer |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
供应产品
Same products