T30 quick pulling with 100ft storage box
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
YQ-2000 casing pressure welding machine |
By tank, power establishment, reversing valve, pressure relief valve, oil pump body, pump oil institutions by the oil hole, high and low pressure o... |
|
movable rodder Vendor |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
eco duct rodderproducer |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
X-I/II/III railway electrification wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
HZ-45 Safety Hydraulic hand Cable wire Cutter |
hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stage hydraulic to ... |
供应产品
Same products