CPC-50A Hydraulic steel Cable cutter tool
Specifications
Hydraulic cable cutter
Head rotates 350 degree
Flip top cutting head rotates 350 degree
Two stage hydraulic to reduce cutting cycle
automaticly release pressure when cutting is completed
Manual release in case of needed
Item No: CPC-50A
Cutting force: 60KN
Other supplier products
|
AS-15 off the shelf tracing duct rod |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
HT-131H open type hydraulic pliers |
according to the frequency of daily use, crimping pliers, pin, shaft and bearing contact surfaces should be timely daub lubricating oil; Crimping p... |
|
professional production insulating rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
Mechanical cable reel stand cable drum jack |
Application: applied in the supporting of reel when laying guiding cable during line construction.Rack jacks suitable for cable tray support, durab... |
|
T2 wholesale quick pulling wire |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
供应产品
Same products