T30 quick pulling with elasticity spring
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
L06S10ECO Fish Tape Fiberglass |
1.Fish type with 7cm wire head,, the end of with a quick pulling wire. 2.Wires for counterclockwise direction of rotation 3.Plastic steel cable pul... |
|
|
Cable pulley |
1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of the m... |
|
|
International L0415 fiberglass 3/17''duct rodder |
Nearly threaded spring wire head bold ribbed steel wire can better protect the end of the line body, prolonging the life of the threader! |
|
|
Supply hydraulic conductor crimping pliers of KDG-150A/200A |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
BF-15 non-store seling duct rodder |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
供应产品
Same products