vapor pressure of the liquefied petroleum gas analyzer FDS-0101
Application range
The vapor pressure of the liquefied petroleum gas analyzer for the vapor pressure of liquefied petroleum gas (GB/T6602-89 "assay (LPG method) in the pressure meter and 37.8 ~ 70oC test temperature, the vapor pressure of the liquefied petroleum gas ( gauge pressure).This instrument applies a higher boiling point than 0oC, the hydrocarbon content is less than 5%, and its vapor pressure is not more than 1550Kpa 37.8oC when LPGFeatures
The instrument consists of a vapor pressure test, constant temperature water bath, temperature control, time control instrument, an electric mixer, pressure gauge.
1, the basic composition of the vapor pressure tester for the upper chamber and the lower chamber.The upper chamber and the lower chamber volume ratio of 2 ± 0.03, respectively, and 4 ± 0.05
2, the water bath for interlayer insulation box filled with insulation materials installed in the main, auxiliary heater and an electric mixer in a water bath.Water bath is installed above the support plate placement vapor pressure tester, at one time were placed two vapor pressure tester
3, temperature control, time control instrument: digital display, temperature range of 0 to 99.9 ° C, a temperature control accuracy: ± 0.1oC, time consciousness: 0 ~~ 999S to alarm.
4, the mixing apparatus: (leaf), the stirring shaft by the stirring motor.
5, the pressure gauge: Range: 0 ~ 2.5Mpa Level: 0.4Specifications
1, the vapor pressure of the test device by the upper chamber and the lower chamber consists of:
Upper chamber: diameter 51 ± 3mm, length 254 ± 3mm (inner wall)
The lower chamber: 33 1/3% of the upper chamber and the lower chamber of a volume ratio of 2 ± 0.03
The volume ratio of 20% of the upper chamber and the lower chamber 4 ± 0.05
2, constant temperature water bath:
Main heating power: 1500W
Auxiliary heating power: 800W
Temperature control accuracy: ± 0.1°C
3 Mixing motor power: 40W
4, the mixing motor speed: 1400 rev / min
5, the vapor pressure tester leakage pressure greater than 3.5MPa
6, the pressure gauge: 0.4 standard gauge ф150mm Specifications: 0 ~ 2.5MPa
Other supplier products
|
|
oil density Tester FDT-1531 |
Application range
Mechanical impurities of petroleum products and additives analyzer is designed in accordance with the national standards GB/... |
|
|
FDH-1701润滑油蒸发损失测定仪 |
适用范围
润滑油蒸发损失测定仪适用标准：SH/T0059将65g 的润滑油装在一个蒸发器里，并加热到 250°C，保持 60 分钟。用一个真空泵将蒸发出的油蒸气随空气流携带出去，测定润滑油的蒸发损失倾向。
功能特点
1、润滑油蒸发损失测定仪采用进口温控控温（欧姆龙），控温精确度高，... |
|
|
Spontaneous combustion point tester FDT-1402 |
Spontaneous combustion point tester FDT-1402
Application range
To meet the DL/T706-1999 IEC79-4: 94"power plants with anti-fuel self-ignition poi... |
|
|
FDH-3831 Dropping Point Tester grease wide temperature range |
Application range
Grease wide temperature range drop point determination of the instrument applicable standards: GB/T3498 ASTMD2265 Scope: Determi... |
|
|
变压器油氧化安定性测定仪 FDH-1001 |
grease drum Stability meter FDH-4401
Application range
The grease drum Stability tester applicable standards ASTM D1831 SH/T0122
Measured w... |
供应产品
Same products
