Metal Wire Bending Fatigue Tester
Main uses:
Metal wire repeated bending tester used for repeated bending test of wire, for different specifications of wire bending radius can be replaced with different round rod, bending position （height） can be adjusted, perforation diameter to replace different bushings.
Test principle:
The sample of a certain diameter is clamped in two round rods of specified size, press the button, the sample is bent at about 90°, the sample is broken, and the bending number is automatically stopped, and the bending number is recorded to test the performance of the metal wire under plastic deformation and the defects displayed during repeated bending.
Meet the standard:
GB/T 238-2013 "Metal material wire repeated bending test method"
GB/T 235 "Metal material thickness is less than or equal to 3mm sheet and thin strip repeated test method"
ISO/DIS 7801-1983 "Repeated bending test of metal wire"
Main parameters:
1, sample diameter: 0.3——6mm or 4——10mm
2, sample length: 150——200mm
3, bending Angle: left and right bending 90 degrees
4. Bending speed: 60 times/min
5. Counting range: 0-9999 times
6. Motor power: 1.1KW
在线联系供应商
Other supplier products
 |
Reciprocating Friction and Wear meter | Applicable Standards ASTM Standards: Formulated by the American Society for Testing and Materials (ASTM), standards such as ASTM D6079 are used to... |
 |
Vertical low temperature cold resistance testing machine | Product description: This machine is used to test finished shoes, rubber, plastic, soles, synthetic leather and other cold resistance degree to un... |
 |
Safety Helmets Against Molten Metal Splashing Tester | Standard GB/T 2812-XXXX: Safety Helmets – Test Methods for Molten Metal Resistance (Draft Standard) GB 2811-2019: Head Protection –... |
 |
Electrolyte wettability test system | Standard ASTM D724-98: Standard Test Method for Surface Wettability of Paper (Angle-of-Repose Method Adapted) ISO 8296: Plastics – Determ... |
 |
Glove cutting resistance tester | Product Introduction: The machine is used to test the cutting resistance of gloves. Under the specified load, the blade cuts the sample to measure... |
Same products
 |
Air Permeability Tester STD- F8 | 卖方: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | 卖方: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | 卖方: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | 卖方: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | 卖方: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
