Glove cutting resistance tester
Product Information:
The machine is used to test the cutting resistance of gloves. Under the specified load, the blade cuts the sample to measure the cutting resistance of gloves. Widely used in fire research institute, fire gloves production enterprises, national quality inspection units.
Main technical parameters:
1, blade: stainless steel blade, hardness is not less than HRC45, the cutting edge length should not be less than 65mm, the width should not be less than 18mm, the thickness of （1.0±0.5）mm, the width of the blade bevel is （2.5±0.2）mm, the Angle of the cutting edge is 22°
2, weight bracket: the sum of its quality and blade quality should not be greater than 200g
3, Tool holder: The Angle between the blade plane and the long shaft of the sample fixture is （90+2）。 The Angle between the cutting edge and the short shaft of the sample fixture is （90+2）。
4, sample fixture: the surface of the arc type of metal fixture, arc radius of （38±05）mm, length should not be less than 110mm, width should not be less than 32mm
5, support frame: can ensure that the sample fixture at the specified rate along the direction of the blade edge
dynamic
6, sample size :50mmx50mm
7,Power supply :AC220V 50Hz 4kW
Meet the standard:
GB/T8965-2009 "Protective clothing flame retardant protection Part 1 Flame retardant clothing"
GA7-2004 Fire gloves
在线联系供应商
Other supplier products
 |
Sock Durability Tester | Product Introduction: Socks wear tester is a special equipment, mainly used to test the wear resistance of socks material. It evaluates the comfor... |
 |
Photovoltaic module wire tube bending testing machine/ Solar PV Module Conduit Bending Tester/ Solar Panel Bend Testing System | Standard IEC 61730-2:2004: Photovoltaic (PV) Module Safety Qualification – Requirements for Testing CE Certification(Conformité Eu... |
 |
Fabric anti-drilling velvet tester GB / T 12705 | Standards: GB / T 12705 Applications: Mainly used in the production of down products and fabric of the anti-drilling velvet test, used to assess... |
 |
Mask Tensile Testing Machine ISO13934-1 ISO13934-2 | Mask Tensile Testing Machine： The electrical part consists of a load measuring system and a deformation measuring system. All control parameters a... |
 |
Water Vapor Permeability Tester | This instrument is professionally applicable to the determination of water vapor transmission rate of plastic films, composite films, high barrie... |
Same products
 |
Falling Sand Abrasion Test machine | 卖方: Standard International Group (HK) Limited | The sand abrasion tester is a specialized testing device used to evaluate the abrasion resistance... |
 |
Conveyor Belt Drum Friction Testing Machine | 卖方: Standard International Group (HK) Limited | Main Purposes of Conveyor Belt Drum Friction Testing Machine The conveyor belt drum friction tes... |
 |
Dry Sand Rubber Wheel Wear Tester | 卖方: Standard International Group (HK) Limited | The dry sand rubber wheel abrasion tester is mainly used to test the abrasion resistance of mater... |
 |
Sliding Bearing Fatigue Testing Machine | 卖方: Standard International Group (HK) Limited | The sliding bearing fatigue testing machine is an important testing device, mainly used to evalua... |
 |
High temperature vacum friction & wear tester | 卖方: Standard International Group (HK) Limited | The working principle of a high-temperature vacuum friction and wear testing machine is to simula... |
