Filter Tester HFP 2000
Test rig for fast and reliable testing of coalescing filter media in relation to fraction separation efficiency and burden.
Filter media test rigs from Qinsun have already proved themselves many times over all around the world in practical applications in development and quality control.
The HFP filter test rig is a modular filter testing system for flat filter media and small mini-filters.
The HFP 2000 can be used to determine :
Pressure loss curve for the new medium ;
Fraction separation efficiency or burden and fraction separation efficiency during application of burden.
Within shortest times –reliably and therefore cost –effectively.
The aerosol generators are easy to interchange and coordinated with the overall system.
As a result ,Filter tests can be performed quickly and easily with the different test aerosols.
With the aid of the light scattering spectrometer digital 2000 ,clear and reliable determination of the aerosol concentration and the particle size and therefore a clear determination of the fraction separation efficiency can be ensured.
The largely automated setup of the test sequence together with the clearly defined individual components and the individually adjustable sequence programs of the filter test software FTC control combine to deliver the high reliability of our measurement results.
Instruction
The aerosol are generated using the Qinsun PLG 2000 aerosol generators or the AGF 3000 for very high mass flows.
A special aerosol processing unit ensures uniform distribution of the test aerosol in the raw gas section .
The horizontal layout of the HFP 2000 test system allows the separated fluid to flow off on the filter medium. The representative sampling for the aerosol measurement is located behind the filter medium.
With the aid of the aerosol spectrometer Digital 2000, the raw gas concentration and the particle size are determined beforehand without a filter.
During the application of the burden on the filter medium, the clean gas concentration is continuously recorded with the digital, thus enabling the fraction separation efficiency to be determined during application of the burden.
Automation
The HFP 2000 has integrated mass flow controller that it uses to control the volume flow:these can be automatically monitored and controlled via the FTC control filter test software.
Integrated sensor data such as the volume flow and differential pressure at the filter are of course also recorded during the filter test.
Measurement of the fraction separation efficiency
Clear demonstration of the separation efficiency of your filter medium throughout the entire measurement range from 0.2 to 0.4 um with the digital 2000 system .
Highest measurement reproducibility and repeatability highlight even fine differences in the separation efficiency
Short measurement times of around 2 minutes per separation efficiency measurement thanks to optimized application.
Simple comparison of separation efficiency curves, calculation of mean values also possible.
Burden/ hold time measurement and record of the pressure loss curve .
Performance of measurements of the fraction separation efficiency during aerosol loading Pressure loss or measurement time can be pre-selected as the abort criterion.
Determination and representation of the pressure loss curve and retention curve in diagram and table form the representation of the particle diameters at 80% and 95% separation efficiency provides additional Information .
Comparison of the fraction separation efficiencies during the different burdening steps
Shortening of the measurement times eg.Through increased aerosol concentration.
Aerosol generator of your choice:
PLG 2000
AGF 3000
Other supplier products
供应产品
Same products
