.

27dBm 900 2600MHz Dual Band Signal Booster

GSM 4G Signal Amplifier 900MHz and 4G 2600mhz Dual band signal repeaters A cell signal booster (also known as cellular repeater or amplifier) is a device that boosts cell signals to and from your mobile whether at home or office or in any vehicle.  It does this by taking the existing cellular signal, amplifying it, and then broadcasting to an area in need of better reception. If you're experiencing dropped calls, slow or lost internet connection, stuck text messages, poor voice quality, weak coverage, low bars, and other cell reception problems, a cell signal booster is the best solution that produces definite results. We provides signal boosters kits for any Homes, Offices, Cars, RV's, Boats and more. All amplifier kits come with Indoor and Outdoor Antennas, Cables, Power adapters and more. HPC-GL-27 Dual band repeater Features: 1.With unique appearance design, have good cooling function 2.With MGC function,(Manual Gain Control), Customer can adjust the Gain as needed ; 3.With DL signal LED display, help to install the outdoor antenna at the best state; 4.With AGC and ALC, make repeater work stable .  5.PCB with isolation function ,make UL and DL signal not influence each other, 6.Low intermodulation, high Gain ,stable Output power  HPC-GL-27 repeater Inside and Outside Design Electrical specification Uplink Downlink Frequency Range 4G 2500-2570 MHz 2620~ 2690 MHz GSM 890-915 MHz 935-960 MHz Max .Gain ≥  70dB ≥  75dB Max .Output Power ≥  24dBm ≥  27dBm MGC ( Step Attenuation ) ≥  31dB / 1dB step Automatic Level Control ≥  20dB Gain Flatness GSM & CDMA Tpy≤ 6dB(P-P); DCS,PCS ≤ 8dB(P-P) WCDMA ≤ 2dB/ 3.84MHz,Full Band ≤ 5dB(P-P) Noise Figure ≤ 5dB VSWR ≤ 2.0 Group Delay ≤ 1.5μs Frequency stability ≤ 0.01ppm Spurious Emission & Output inter-modulation GSM Meet  ETSI TS 151 026 V 6.1.0 WCDMA Meet 3GPP TS 25.143 ( V 6.2.0 ) CDMA Meet  IS95 & CDMA2000 WCDMA System Spurious Emission Mask Meet 3GPP TS 25.143 ( V 6.2.0 ) Modulation Accuracy ≤ 12.5% Peak Code Domain Error ≤ -35dB@Spreading Factor 256 CDMA System Rho ρ  > 0.980 ACPR Meet IS95 & CDMA2000 Mechanical  Specifications Standard I /O Port N-Female Impedance 50 ohm Operating Temperature -25ºC~+55ºC Environment Conditions IP40 Dimensions 220x320x40mm Weight ≤ 3.00Kg Power Supply Input AC90-264V,output DC 5V / 6A LED  Alarm Standard Power LED Power Indicator UL LED Be lighted when there is calling DL 1 Be lighted when Outdoor signal is -65dB DL 2 Be lighted when Outdoor signal only -55dB DL 3 Be lighted when Outdoor signal only -50dB HPC-GL-27  Dual band repeater is to support any two mobile band existing in the world to help end users to improve mobile signals for much better call quality and smoother data transmission. It is designed to support coverage area max can up to 2000 square meters with proper engineering. Below are the main features. 1.The consumer repeater is an ideal solution for providing a cost effective improvement in cellular in-building coverage of a home, office, restaurant or building, in the quickest time possible. 2.Manual gain control (MGC) available for both uplink and downlink to adjust the gain value for proper coverage during installation or maintenance. 3.To maintain safe and specific output signal levels and give alarms on self-oscillation, the repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater depending upon the strength of input signals. 4.Auto shut off function available for both uplink and downlink to avoid deep self-oscilation from jamming the towers, saving your trouble from operators.  5.Wide band feature enables all devices operating within the wide frequency range of the repeater to see an improvement in performance. 6.Multiple s and other handheld devices throughout a building can benefit from a wireless repeater. 7.Supports up to (500) users / calls simultaneously. 8.Extended battery life. (Your does not need to put out as much power due to improved reception.) Specification of HPC-GL-27 Dual band repeater: (Note : Omni indoor antenna is 3dBi,it can work with about 200m2 . If need repeater coverage larger area , need add more antenna,the HPC-D4G-27 Max can work with 10pcs indoor antenna.  ( when add antenna ,please remember to take splitters ) Installation steps  Step 1 Start by taking your up to the roof or other location outside to find where the signal is strongest. Step 2 Temporarily mount the Outdoor (outside) antenna in that location. You may need to adjust and move the antenna later. Step 3 Run coaxial cable into the building to a convenient loaction (attic, etc.) where you can also get standard power for the Signal Repeater. Step 4 Place the Signal Repeater in that location and connect the coaxial cable to the Outdoor Side of the Signal Repeater and the Outdoor antenna. Step 5 Mount your Indoor (inside) antenna in a productive location. You may need to adjust or move the antenna later. More notes on Indoor antennas and patterns here. Step 6 Connect coaxial cable between the Indoor antenna and the Signal Repeater output port. Step 7 Power up the system and check for signal inside the building. If needed, tune system by moving and or pointing the Outdoor and Indoor antennas until they get the most signal possible. Step 8 Secure all antennas and cables, securely mount the Signal repeater and clean up the installation. Of course there are still a few more things to consider but in general, this is the basic procedure. For more information, please contact us. Terms and Conditions Certificate CE/RoHs Country of Origin China Port of Dispatch Shenzhen Production Capacity 1000pcs/month Date of Delivery Within 3 days after received payment inform MOQ 10pcs Warranty 2years Pacakge 1pcs/box; 5pcs/carton Country of Origin China


在线联系供应商

至: Shenzhen Sai Tong Tian Electronic Technology Co.,LTD
Your E-mail:
消息正文:


Send to other suppliers

Other supplier products

Outdoor Repeater PCS1900mhz Network Output 5wattsThe DCS1800mhz RF Repeater is designed to provide a more cost –effective solution than adding a ne...
5watts 3G signal booster ST-3G&5W Max coverage 6000sqm What is the booster?Cell signal booster (also named repeater,Website:, amplifier) is a prod...
HPC-CW-27 CDMA850 and LTE2100mhz Dual band signal repeatersA cell signal booster (also known as cellular repeater or amplifier) is a device that b...
A whole set of 27dBm High Quality Low Cost GSM Single Band Signal Booster include: one GSM single band booster one indoor ceiling antenna one ou...
5watts 1900mhz repeater ST-1900&5W Max coverage 6000sqm What is the Tele signal booster? Mobile Signal Booster is specially design...
供应产品

Same products

Techwin Spectrum Analyzer TW4900 for ComTechwin Spectrum Analyzer TW4900 for Comprehensive assessment of the performance of electronic systemsprehensive assessment of the performance of electronic sys
Techwin Spectrum Analyzer TW4900 for ComTechwin Spectrum Analyzer TW4900 for Comprehensive assessment of the performance of electronic systemsprehensive assessment of the performance of electronic sys 卖方: Hangzhou Techwin Precision Instrument Co.,Ltd Techwin Spectrum Analyzer TW4900 for Comprehensive assessment of the performance of electronic sy...
Techwin Vector Network Analyzer TW4600 for wireless communications and cable TV
Techwin Vector Network Analyzer TW4600 for wireless communications and cable TV 卖方: Hangzhou Techwin Precision Instrument Co., Ltd Techwin Vector Network AnalyzerTW4600for wireless communications and cable TV www .techwin-china...
Sim7600e
Sim7600e 卖方: 深圳市启穗电子科技有限公司 Sim7600e,4G LTE Module
Sim7100c
Sim7100c 卖方: 深圳市启穗电子科技有限公司 Sim7100c,Website: LTE Module
Sim7100ce
Sim7100ce 卖方: 深圳市启穗电子科技有限公司 Sim7100ce,Website: LTE Module