Key Copy Tool
With USB port 9-PIN serial adapter for connection with a computer.
Could automatically identify chip ID number and read out the data of different chips.
Support 11, 13, 33, 53, 73, 93, and 4C keys.
Can perform encrypt for T5 keys and prevent from copied
Can read out key data and directly write it to the corresponding file in the Engine Control Module; start the engine directly, no adaptation is needed.
Support on such Auto key adapting of CAN system, such as M6, Ford and SRX.
With the function of saving all the data of the chips, so when you need, you can get the chip data from it.
It is the special device composing of all the function of reading, writing and copying Auto chips.
With Chinese & English using manual.
Guarantee for repair: 1 year.
view the manual, please to check the PDF file.
Other supplier products
|
|
X431 PC Center |
X-431 PCCENTER is an inclusive data management software kit integrating monitor, diagnosis, analysis, waveform display, update notice and remote se... |
|
|
Honda GNA600 |
Honda GNA600 interface module kit works with the OEM-Honda Diagnostic PC Software (HDS). This is the replacement for the previous dealer tool Honda... |
|
|
T300 key programmer |
Used for programming of car keys. Models coverage: Acura, Audi, Alfa, Chevrolet, Citroen, Chrysler ( Dodge, Jeep), Daewoo, Ford Japan, Ford USA, F... |
|
|
FORD(FOCUS), MAZDA Keymaker |
Focus keymaker is very good device. It can make keys for Focus (from 2003 ) and RX8 of MAZDA.
Only this device, no PC. Make Focus`s keys via BDM o... |
|
|
X 431 diagnostic tool |
If you run your own automotive shop, consider for a moment how long it takes to discover and diagnose complex problems within the engine or vehicle... |
供应产品
Same products
