T30 quick pulling wire 30m with sleeve
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
THS-150 hydraulic crimping pliers |
Hydraulic crimping pliers:Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
|
|
EP-510BH terminal crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
4.5mm X 100 Metre Fiberglass Rodder |
Outer protect layer are made of high density polyethylene engineering plastic, which Duct rodder/ Cobra Conduit Rod is composed of fiberglass rod w... |
|
|
L06S30 ECO Fishtape Puller |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
Cable pulling Grips made by high grade galvanized steel |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
All supplier products
Same products