T30 quick pulling wire 30m with sleeve
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
PZ 0.5-16 Manual line pressing pliers |
Manual type crimping pliers:Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
4.5mm X 100 Metre Fiberglass Rodder |
Outer protect layer are made of high density polyethylene engineering plastic, which Duct rodder/ Cobra Conduit Rod is composed of fiberglass rod w... |
|
Three Wheel Corner Pulley |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
cable stand with jacks as power |
Features It is applicable to be as the support of large cable reel in laying cables in the city. It is easy to move with the trundles in the bottom... |
|
W0850T electric cable puller |
1. It is easy to lead, can be used in narrow passage and limited space 2. A lot of the handle, the user can better control to use 3. Self expansion... |
供应产品
Same products