L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
AF-15 NNEP duct rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
TC-100 Hand Cable Wire Cutting tool |
Features: The handle is made of high tensive aluminum alloy, the knives are made by forging, long life span. Item No: TC-100 for cutting cable Cutt... |
|
|
FYQ-400 electric hydraulic clamp with electric pump |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
DP021 electric tools cable stand, jacks |
These A-Frame cable stands with hydraulic bottle jacks are a compact solution for spooling heavy drums of power and data cable or conveyor belts. T... |
|
|
TC-250 patchwork cutters |
Feature: TC-250 hand cable cutting tool with forging , long life span The handle is made of high tensive aluminum alloy, the knives are made by for... |
All supplier products
Same products
