L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
EZ-45 power cable cutter |
Cutting force: 60KN Stroke: 50mm Cutting cycle: 130 times Cutting range: dia 45mm (Cu/Al cable and armoured cable) Voltage:18v Capacity: 3.0Ah Char... |
|
|
Gasoline motor cable winch |
1. small size & compact structure. The machine is now supported by gasoline engine, diesel engine, electric or imported gasoline engine. 2. lig... |
|
|
EZ-1632 charging crimping pliers of German type |
parameter specification: Product model: EZ - 400 plug-in crimping pliers Output: 120 kn Scope: pressure was 16-400 Stroke: 38 mm Pressure welding n... |
|
|
Hydraulic steel cable cutter, steel wire rope cutter |
Specifications hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stag... |
|
|
cable drum jacks with 5T 10T 15T |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
供应产品
Same products
