W0830 fish type three braid
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
7/8" stainless steel wire mesh grips |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
BS-15 DNP eco duct rodder |
Fish Tape is designed for flexibility and easy navigation through conduit runs. The polypropylene case and handle are extremely durable and offer t... |
|
|
HZ-45 Hydraulic cable cutter |
Specifications Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Two stage hydraulic to reduce cutting cycle,autimatic release pressure ... |
|
|
W0830 Good Rigidity Duct Rodder |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
Electric supplies cable jack,Cable drum jacks,Plate cable stand |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
All supplier products
Same products
