W0830 Good Rigidity Duct Rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
WY-430 manual hydraulic crimping pliers |
Hydraulic crimping pliers：Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
|
|
Multi Function Heavy Duty Ratchet Cable Cutter |
J50 Cutting capacity: Armored cable,ACSR, copper, aluminium cable(dia 50mm) J75 Cutting capacity: Aluminium armored cable dia75mm, Copper armored c... |
|
|
Auxiliary tool for construction, cable winch |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
|
|
CPC-40B Split hydraulic Cable Cutter |
Specifications: CPC-40B Split- unit cable cutter head hydraulic cable cutter Flip top cutting head rotates 350°. Two stage hydraulic to reduce ... |
|
|
Manufacture cable laying drum roller Cable drum jack |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
All supplier products
Same products
