W0830 Good Rigidity Duct Rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
TC-38 Manual cable cutter Tool of copper |
Features: 1.Strong,light weight glass fiber handle. 2.Adjustable pivot bolt realized adjustable blade. 3.Changeable,forging blade heat treated and ... |
|
|
BF-15 cash on delivery duct rodder |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
|
|
EZ-400 Plug-in crimping plier |
1 The head can rotate 360, two-speed double-acting hydraulic equipment by design 2 When the pressure to complete stop of the motor and automaticall... |
|
|
high quality Glass fiber reinforced plastic cleaning rod |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
Service Drum Dispenser Horizontal Drum Dispenser |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
供应产品
Same products
