L0750T Export standard duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
T50 accessories-good easy to pull |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
AS-15 specially produce movable rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
Electric Powered Winches,cable puller,Cable Drum Winch,Cable pulling winch |
Mechanical drum trailer and hydraulic drum trailer Application: used for cable drum hauling and cable pulling-pushing. simple operation, stable and... |
|
|
LBJ-25 Al-clad steel stranded wire grip,25KN wire rope clips |
Directions for manufacturer, whole saleand retail for all kinds of grips.TheCable Grip/clampsare widely used in power cable and communication line ... |
|
|
Cable pulling equipment straight cable rollers for cable installation |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
All supplier products
Same products
