L0750T Export standard duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
low price Cable pulling winch, new type Powered Winches,Cable Winch |
Mechanical drum trailer and hydraulic drum trailer Application: used for cable drum hauling and cable pulling-pushing. simple operation, stable and... |
|
stainless steel cable socks |
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique desi... |
|
BF-45 exportation fish tape |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
tractor cable winch |
engine winch/Cable Drum Winch Application: It's used for erecting pole, hoisting, stringing wire in power line operation. Powered winches are the c... |
|
Cable pulley with bracket |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
供应产品
Same products