W0850 portable shelves duct rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
cable puller,Cable Drum Winch,Cable pulling winch |
3T AND 5T Petrol Engine Powered Winches This engine winch is used to work for tower assembly or moving heavy and bulky materials when stringing wor... |
|
|
Nylon Pulley for cable belt nylon roller |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
split wire mesh grip |
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and ca... |
|
|
Manhole Triple Roller |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
|
|
Hydraulic type cable dispenser |
Application: Suitable for cable tray support. Hydraulic lifting, casters at the bottom, easy to move. For line construction, extending wire shelvi... |
All supplier products
Same products
