W0850 portable shelves duct rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Equipment for the cable depot Cable-drum take-off rollers |
Purpose: applicable to the line of the line construction in the development and release of the disc Features: the exhibition release speed is stabl... |
|
|
cable dispenser truckle |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
|
BS-30 non-store seling movable rodder |
Flexible reinforce fiberglass core with polyethylene coating. professional electricians rely on brand! It is Light, Strong and Smooth with a steel ... |
|
|
Hose Restraints and Marine Cable Grips |
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique desi... |
|
|
Hydraulic Cable Drum Jacks, Cable Jack Stand |
Hydraulic Cable Drum Jacks, Cable Jack Stand is used for supporting the cable drum when laying cable, With the trapezoidal structure, hydraulic cab... |
供应产品
Same products
