T2 cable puller accessories
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
CC-50B split cable cutting head |
Length: approx.340mm Weight: approx.6.20kg Package: steel case Weight of case: approx.2.10kg Note:it can use with any hydraulic hand pump or electr... |
|
scraper movable rodder |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
Direct selling fish tape |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
T30 quick pulling wire 30m with sleeve |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) |
|
HZ-45 Hydraulic Hand Armoured cable cutter |
hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stage hydraulic to ... |
All supplier products
Same products