T50 Electricians Puller Rods Wires Draw Push Pulling
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
Electrical Technician movable rodder |
Feed device allows rod to feed out or be back with easy push or pull of rod Rugged tubular steel reel with adjustable positioning Rustproof bull-no... |
|
|
Cable pulley |
1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of the m... |
|
|
GOB-10 High voltage cable insulation stripper |
Specifications: GOB-10 Outside diameter of cable:15-30mm Thickness of the insulating layer: ≤10mm Weight: 0.83kg GOB-12 Outside diameter of cabl... |
|
|
Wire Cable Running Rod Duct Rodder Fishtape Puller 4.5mm |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
Cable pulling Grips |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
All supplier products
Same products