T50 Electricians Puller Rods Wires Draw Push Pulling
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
Cable Pulling Snake push pull rod duct rod |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
Suppliers insulating rodder |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
|
|
electric lifting winch |
It's used for erecting pole, hoisting, stringing wire in power line operation. Powered winches are the construction tools of erecting electric circ... |
|
|
K95 klauke integral mechanical crimping pliers |
Air pressure welding clamp also belongs to the manual class: air pressure welding clamp is suitable for 1.25 5.5 mm&sup 2; Bare terminal, insul... |
|
|
L06S50 Tracing Duct Rod |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
供应产品
Same products