T30 quick pulling / good leading tools
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
CONNER CABLE ROLLER |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
Large Y.O insulation terminal wire clamp |
Manual type crimping pliers:Using high and low two levels of plunger pump driven design, operation fast and effort; System is equipped with safety ... |
|
SKG-10 round strand wire rope clips |
The high strength aluminum alloy manufacture and, light weight, small volume, function. After heat treatment, high tension resistance, occlusal str... |
|
direct selling eco duct rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
BF-60 Customized frp push pull rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
All supplier products
Same products