T30 quick pulling / good leading tools
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
FRP snake rod for communication and construction |
Feed device allows rod to feed out or be back with easy push or pull of rod Rugged tubular steel reel with adjustable positioning Rustproof bull-no... |
|
|
T30 ELECTRICIANS PULLER RODS WIRES |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
L06S50 Direct Marketing duct rodder |
Features: Made of special plastic steel, three braid by machine, when using not loosen, Wire head pressure in good condition, won’t fall off,... |
|
|
engine winch,Cable Drum Winch,Powered Winch |
(1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane to move or skewed. (2) run one end of the rope... |
|
|
Cable Drum Handling 5tons and 10 tons Braked Drum Stand |
applicable to be as the support of large cable reel in laying cables in the city easy to move with the trundles in the bottom can be equipped with ... |
供应产品
Same products