L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
cable puller/Cable bollard winch |
Cable winch is an essential part of the erection of the underground cable lines, vertical bars and other construction products, can be in a variety... |
|
|
CPC-100B split cable cutting head |
Split hydraulic cable cutter can work with hydraulic hand pump or electric hydraulic pump, it is suit for big size of tele cables or armoured Cu/Al... |
|
|
push pull rod cable access kit cable puller |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
Wire Cable L0410 Running Rod Duct Rodder Fishtape Puller 4.5mm |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
THC-20 Safety manual hydraulic wire cable cutter up to 20mm |
THC-20 Safety hydraulic manual rebar cutter 1.Rotate head 180degree 2. Flip top cutting head 3.Easy changeable cutting blade 4.Single hydraulic plu... |
All supplier products
Same products