L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
HZ-45 Hydraulic Cable Cutters with safety valve cutting 45mm cable |
hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stage hydraulic to ... |
|
|
Cable Drum Lifting Jacks |
Hydraulic Cable Drum Jacks, Cable Jack Stand is used for supporting the cable drum when laying cable, With the trapezoidal structure, hydraulic cab... |
|
|
Nylon Pulley for cable belt nylon roller |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
Hot sales Coil unwinder / roller Drum Roller Rails |
Cable stand appearance; horizontal cable stand and a vertical cable line frame, large cable line frame, heavy cable stand, trapezoidal cable rack, ... |
|
|
cable puller,Cable Drum Winch |
cable winch is composed of a roller wheel, gearbox, diesel or gasoline machine and a base frame, the mobile cutter grinding principle: cutter grind... |
供应产品
Same products
