L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
Drum Roller Rails Cable Drum Rotators Coil unwinder / roller |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
|
|
X-I/II/III railway electrification wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
T30 ELECTRICIANS PULLER RODS WIRES |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
Cable laying roller |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
CPC-65C/85C/105C/120C Hydraulic Wire CableCutting Head |
CPC-65C/85C/105C/120C Hydraulic Wire Cable Cutting Head 1.Opening C type cutting head 2.Hydraulic quick couper connect with the pump for working 3.... |
All supplier products
Same products
