W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BS-30 Indoor type movable rodder |
A mechanical puller will severely damage the tape, and could lead to personal injury. Use a safe work position to avoid loss of balance when using ... |
|
|
Vendor insulating rodder |
Polyethylene cover: Medium density polyethylene resin for the insulating and jacketing of cables.Rolling bearing cage flotation (reel transport) fo... |
|
|
fish tape with strengthen the core |
Polyethylene cover: Medium density polyethylene resin for the insulating and jacketing of cables.Rolling bearing cage flotation (reel transport) fo... |
|
|
T30 quick pulling / good leading tools |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
split wire mesh grip |
Application: designed to securely grip all types of bare cables which is devoid of end fittings. Standard cable socks are available in a range of s... |
All supplier products
Same products
