W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
7/8" stainless steel wire mesh grips |
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additi... |
|
|
BS-30 FOB cable duct rod |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
|
Manhole roller |
Used in the cable changing the direction place protection cable not to wear,frames of corner rollers are linked together with stake pins to form a ... |
|
|
EZ-85 Battery power hand held tools |
1. All tools can be controlled by one key-press the trigger to start working, half loosing the trigger means stopforcing pressure, loosing fully me... |
|
|
X-I/II/III railway electrification wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
供应产品
Same products
