L0750T CBRL duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
professional production Glass fiber reinforced plastic cleaning rod |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
TC-500 cutting tools scrap |
TC-500 Max 500mm2 Hand Manual Cu/Al conductor Cable Wire Cutter The handle is made of high tensive aluminum alloy, the knives are made by forging, ... |
|
|
push pull rod cable access kit cable puller |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
provider Glass fiber reinforced plastic cleaning rod |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
AS-15 wire coating duct rod |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
All supplier products
Same products
