L0750T CBRL duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
3 drum corner Cable pulley roller block |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
6-9mm cable mesh grip/steel wire mesh grip/connection for cable |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
|
|
T30 ELECTRICIANS PULLER RODS WIRES |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
|
fiberglass push pull rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
cable wire stripper |
Quick & easy maneuverability. Sharpening type: copper aluminium cable. Aluminum alloy body, light to carry. On both ends of the positioning str... |
供应产品
Same products
