Cable Pulling Grips/side pull steel wire mesh for cable
Pulling grips Styles and Applications
1.Medium duty pulling grips are double weave for added strength with greater mesh contact on the cable to handle longer or heavier pulling jobs.
2.light duty pulling grips are single weave with a flexible eye for easy attachment to a pulling line. Cable Pulling Grips are used in general underground electrical construction where pulling tensions are low.
3.slack pulling grips are made of galvanized steel and come in three styles with a single offset eye for easy attachment to a pulling line. cable socks Closed, when the cable end is accessible, split lace and rod closing when cable end is not accessible. Cable grip are used in pulling slack for final placement of underground cable after Cable Pulling Grips has been pulled and longer mesh for higher pulling loads where space is not restricted.
Other supplier products
|
|
cable stand with jacks as power |
Application Hydraulic Cable Drum Jacks,/Cable Jack Stand is applicable to the placement of the cable tray, with hydraulic lifting. Features It is ... |
|
|
Direct selling duct rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
Fiberglass Reel Wire |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
preformed dead end grip for cables |
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and ca... |
|
|
new type eco duct rod |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
All supplier products
Same products
