preformed dead end grip for cables
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and can also be used to support or pull any cylindrical object within their grip and load carrying capacity.
These Grip offer a flexible eye and double weave stainless steel wire construction for regual load pulls.Always read Breaking Strength,safety and technical data informatin. The approx mesh lengthis measured at an average grip diameter.
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
hydraulic cable jacks |
Features It is applicable to be as the support of large cable reel in laying cables in the city. It is easy to move with the trundles in the bottom... |
|
|
Direct Marketing duct rodder |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
Electrical Technician fish tape |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
FRP duct rod |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
|
Cable Stand,electrical cable stand,Hand Cable drum jacks |
Application: for general outdoor underground cable Actinobacillus operation, high-altitude stringing House switchboard construction wiring. Operati... |
All supplier products
Same products
