preformed dead end grip for cables
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and can also be used to support or pull any cylindrical object within their grip and load carrying capacity.
These Grip offer a flexible eye and double weave stainless steel wire construction for regual load pulls.Always read Breaking Strength,safety and technical data informatin. The approx mesh lengthis measured at an average grip diameter.
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
Mechanical cable reel stand cable drum jack |
applicable to be as the support of large cable reel in laying cables in the city easy to move with the trundles in the bottom can be equipped with ... |
|
NEW- 10mm x 490' Duct Rodder Fish Tape |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
SNAKE CABLE DUCT PULLER NBN |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
|
fiberglass snakes |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
tractor cable winch |
Powered Winches,Cable Winch,ENGINE WINCH,Cable Drum Winch,Cable pulling winch Application: It is used for tower erection, stringing in electric pow... |
供应产品
Same products