Hose Restraints and Marine Cable Grips
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
|
factory direct sales duct rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
pulling cable grips |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
narrow pipes with fish tape/ duct rod |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
SJKL-1 insulated wire rope clips |
Match with delicate smooth clamp mouth, minimal harm to wires
Made of high-tensile forged carbon steel
Half-moon shape clamping jaw is suitable for... |
|
|
stainless steel cable socks |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
All supplier products
Same products
