Cylinder inside the drying device
An overview of the
Cylinder inside the drying device is according to the regulations of relevant national standard design and manufacture. Cylinders after water wall residue a lot of water, remove it
Some water is the most simple method is to use hot air blow. This device USES electric heating mode. Temperature is adjustable, the hot air to the cylinder internal fan for dry
Dry. There are electric heater and fan equipment configuration. Compact structure, easy installation, simple to use, reliable performance, is an essential part of cylinder internal dry only
One of the used equipment.
Main technical parameters
Models: GZ - 01
(1) apply the cylinder: diameter from 219-426 - mm 600-2000 - mm length
(2) set temperature: 0-100 ℃
(3) total energy rate: 17 kw
(4) double rack: 2 locations
(5) working efficiency: 12 or higher/h
(6) overall dimensions: about 21
Other supplier products
|
|
fluid pump |
Seth fluid pump is by Seth company introduction of foreign products technology, continuous innovation to improve and become, Seth fluid pump has th... |
|
|
GPV air booster pump |
air booster pump is applicable to the original air compressor system to improve
Pressure working environment, the working system of air pressure
Up... |
|
|
L series drive liquid booster pump |
L series gas-liquid booster pump adopts embedded single pneumatic non-equilibrium gas distributing valve to realize the pump automatically reciproc... |
|
|
STT series air drive gas booster pump |
STT series pump for secondary pump, can be very low pressure to high pressure gas. Drive 8 b a r, or less gas input port
Pressure range is 0.1-10 b... |
|
|
adlocks FL08 flange type machine |
Padlocks FL08 type flange machine 2Seth, padlocks FL08 flange type machine (flange litelocker) is a strong and advanced locking type, it can be two... |
All supplier products
Same products
