Wide-Load Friction and Wear Test Equipment
Whats/App: +86 156 1874 6768
Web: standard-groups.com
Standards
The system supports test methods commonly referenced in international tribology standards, including:
ASTM G99 (Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus)
ASTM G133 (Linearly Reciprocating Ball-on-Flat Sliding Wear)
ISO 7148 (Plain Bearings — Testing of Friction and Wear)
JIS K 7218 (Testing Methods for Plastic Tribological Properties)
Parameters
| Parameter | Specification |
|---|---|
| Load range | 20 g to 100 kg |
| Low-load method | Balance arm loading (20 g to 10 kg) |
| High-load method | Lifting-type weight loading (10 kg to 100 kg) |
| Rotational speed | 30 to 3000 rpm |
| Test mode | Rotational friction and wear testing |
| Measurement methods | Torque meter or force load cell (selectable) |
Features
Extremely wide load range from very low loads to high loads within a single system
High-sensitivity balance arm ensures accurate measurement in low-load testing
Stable lifting-type weight loading structure enables safe high-load application
Rotating table design optimized for wear testing from low to high speeds
Capable of accelerated wear testing under high load and high speed
Compatible with various wear test configurations through optional accessories
Suitable for lubricant testing and high-temperature wear testing when equipped with optional devices
Accessories
(1) Control frame
(2) Ball indenter, 5 mm diameter
(3) Ball indenter, 10 mm diameter
(4) Ring-type loading weights
(5) Tool set (Phillips screwdriver, flathead screwdriver, wrench)
(6) Parts storage box
(7) Power cable
(8) Ground wire
(9) Operating manual
Test Procedures
Install the appropriate test fixture and mount the test specimen securely.
Select the required loading method according to the test load range.
Set the target load using balance arm weights or lifting-type weights.
Adjust the rotational speed according to test requirements.
Choose the friction measurement method (torque or load cell).
Start the test and monitor friction and wear behavior during operation.
Stop the test after the specified duration and evaluate wear results.
Maintenance Information
Clean the rotating table and contact components after each test
Inspect loading mechanisms and balance arms regularly
Verify load accuracy and sensor performance periodically
Keep moving parts properly lubricated as specified
Store the instrument in a clean, dry environment
Send product request
Other supplier products
 |
Vibration Table | Whats/App: +86 156 1874 6768 Web: standard-groups.com Standard ASTM D999: Vibration testing of shipping containers and packaged products. TAP... |
 |
Zipper torsion tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com The zipper torsion tester is used to test the binding strength of the zipper pull head and ... |
 |
Scrub Abrasion Tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com T107 Scrubbing Tester, It is suitable for various abrasion and wet scrubbing tests, which i... |
 |
UL Horizontal and Vertical Flammability Tester，EN Horizontal Vertical Flame Tester | Whats/App: +86 156 1874 6768 Web: standard-groups.com Introduction UL94 horizontal and vertical combustion testeris designed to simulate the ear... |
 |
Catheter Flow Meter | Whats/App: +86 156 1874 6768 Web: standard-groups.com The Catheter Flow Meter is specifically designed for measuring the water flow rate of medic... |
