Plastic Pipe Mold
Plastic Pipe Mold
The gas-assisted controller is used to control the pressure of nitrogen to the pipe fitting mould at different times, the controller is divided into a single air circuit, double air circuit, and four air circuits, each gas path during gas assisted pipe injection molding can be individually controlled in terms of injection time and injection pressure, the most advanced controllers all use microprocessors in the world, full closed-loop control, and stopless voltage transformation technology.
As one of injection mold manufacturing companies, we can offer kinds of plastic injection molding parts for sale, anything you need, please leave us a message.
Other supplier products
|
|
Car Door Mold |
Car Window Mould
Automotive Door Bracket Mold can shorten the fixture wasting(the fixture will improve the slight deformation) and it has very goo... |
|
|
Automotive Water Intake Manifold Mould |
Automotive Water Intake Manifold
Injecting gas through the nozzle is a typical method used in rod-shaped products, because this method does not re... |
|
|
Gas & Water Assisted Injection Mold |
Gas Assist Injection Molding Design Guide
Since the thermal conductivity and heat capacity of water are much bigger than nitrogen, so the inject... |
|
|
Multi Cavity Mold |
Multi Cavity Mold
The runner filling balance must be considered when designing the multi-cavity mold in order to ensure the best effect of filling... |
|
|
Drip Tip Mold |
810Drip Tip Mold
2k Electronic Cigarette Drip Tip Moldadvantages:
plastic injection moldingcycle is short, suitable for large-volume prod... |
All supplier products
Same products
