Scratch tester
Product Introduction:
With the continuous expansion of the use of plastic molding products, from the point of view of the surface appearance of molded products （creativity）， improving scratch resistance （scratch characteristics） has become an important topic. And scratch resistance is also very important from the point of view that scars formed on the surface of the molded product may reduce the strength of the product. Scratch testing is performed by horizontal movement of the scratch needle against the pattern. Scratch characteristics were previously evaluated by a "constant vertical load test", but the American Society for Materials and Testing （ASTM） and the International Organization for Standardization （ISO） standardized the "vertical load test" （ASTM D7027-05/S019252）。
Scope of application:
The tester uses a steel needle to scratch films, plastics, automotive interior and exterior decorative materials, coating materials, etc., to evaluate the material's "scratch resistance" （scratch characteristics）。
Features of scratch tester:
1. Teaching function
Use this function to set the load zone with high precision before sampling.
2. Easy to operate with touch screen
All functions can be used and configured through the touch screen installed in front of the Settings.
3, the surface has a bump can also test scratches
The Yaru drive for vertical loads uses a county frame mechanism, so that even the surface with a concave and convex pattern can be tested without affecting the linear increase in load characteristics.
4. Memorizable test conditions
Storage capacity up to 20, capable of memorizing test conditions.
Technical parameters:
The STD-02 is fully compliant with I50 and ASTM International standards
Size :W545*D455*H680（mm）
Weight: About 65KG
Test mode: Load increase mode
Speed range :1——200 mm/sec
Vertical （z） load control range :1——50N
Horizontal （x） load test range :50N
Send product request
Other supplier products
 |
FB4 - A Surface Performance Tester | Content TheSurface Tester analyzes finger movements-particularly, strokes-performed by artisans and professionals when judging a fabric’s ... |
 |
Safety Helmets Impact and Penetration Resistance Tester | Standard GB/T 2811-2019(China’s national standard for helmet safety and impact resistance) GB/T 2812-2006/XXXX(Testing methods for impact a... |
 |
Sock wear tester | Product Information: Socks wear tester is a special equipment, mainly used to test the wear resistance of socks material. It evaluates the comfort... |
 |
Pilling assessment viewer | Universal pilling pilling viewer/Pilling Pilling Rating tester By comparing the sample to the standard card under the specified light source to obt... |
 |
Shirley Moisture Permeability Tester | Standards: 1. BS 7209 Specification for Water vapor permeable apparel fabrics 2. BS 3424 testing coated fabrics. Applications: Produ... |
Same products
 |
Air Permeability Tester STD- F8 | Seller: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | Seller: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | Seller: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | Seller: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | Seller: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
