Glove Cut Resistance Tester
Product Introduction:
The machine is used to test the cutting resistance of gloves. Under the specified load, the blade cuts the sample to measure the cutting resistance of gloves. Widely used in fire research institute, fire gloves production enterprises, national quality inspection units.
Main technical parameters:
1. blade: stainless steel blade, hardness is not less than HRC45. the cutting edge length should not be less than 65mm, the width should not be less than 18mm, the thickness of (1.0±0.5)mm, the width of the blade bevel is (2.5±0.2)mm, the Angle of the cutting edge is 22°
2. weight bracket: the sum of its quality and blade quality should not be greater than 200g
3. Tool holder: The Angle between the blade plane and the long shaft of the sample fixture is (90+2)。 The Angle between the cutting edge and the short shaft of the sample fixture is (90+2)。
4. sample fixture: the surface of the arc type of metal fixture, arc radius of (38±05)mm, length should not be less than 110mm, width should not be less than 32mm
5. support frame: can ensure that the sample fixture at the specified rate along the direction of the blade edge
dynamic
6. sample size :50mmx50mm
7.Power supply :AC220V 50Hz 4kW
Meet the standard:
GB/T8965-2009 "Protective clothing flame retardant protection Part 1 Flame retardant clothing"
GA7-2004 Fire gloves
Send product request
Other supplier products
 |
Safety Helmets Wearing Stability Tester | The Safety Helmets Wearing Stability Tester is designed to evaluate helmet retention and fit under dynamic conditions, simulating real-world head m... |
 |
Spring Testers and Testing Machines | The Spring Tension and Compression Testing Machine is designed to accurately evaluate the tensile and compressive deformation, as well as the load ... |
 |
Keyboard Key Life Tester | standards GB/T4967-95 silicone rubber and keypad life testing equivalent to JIS and IEC standards Experimental principle The use of a motor driv... |
 |
Surgical Mask Flame Retardant Tester | The Surgical Mask Flame Retardant Tester is designed to evaluate the flame-retardant performance of surgical masks. In the event that a mask is acc... |
 |
Water Leak Detector | GB/T 21619-2008 Test Methods for Dangerous Goods Flammable Solids Emitting Flammable Gases in Contact with Water, GB 19521.4-2004 Safety Standard f... |
Same products
 |
Air Permeability Tester STD- F8 | Seller: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | Seller: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | Seller: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | Seller: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | Seller: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
