MARK-II anti-slip testing machine
Paste the cut sample on the test fixture of the portable MARK-II anti-slip testing machine, put down the weight of the rotating support frame on the test fixture, so that the test piece is pressed on the floor interface by a fixed force, and tilt the rotating support frame of the portable MARK-II anti-slip testing machine, so that the horizontal thrust subjected to the test piece is gradually increased. Until the test piece slides instantaneously. The value of friction coefficient that should be dealt with before the sole test piece slides instantaneously is the large static friction coefficient of the test sole on the floor interface, that is, the anti-slip coefficient.
Reference standard:
ASTM F1677 and other standards
Technical specifications:
1. Sample size: （76±1）*（76±1）mm.
2. Load: 10IBS.
3. Floor requirements: horizontal floor.
4. Volume: 40*22*39cm.
Send product request
Other supplier products
 |
Bone Screw Pull-out Tester | Standard YY/T 1506, ASTM F543: The standard specifies the torque required to measure the torque required to screw a metallic bone grafting screw ... |
 |
Automatic open flash point tester | Product Introduction: The instrument can automatically test the flash point and ignition point of petroleum products （the ignition point of oil ex... |
 |
Automotive Interior Materials Droplet Characteristics Tester | Standards: 1. 1995L0028-EN-01.01.2007-002.001-25 ( ANNEX V) Measurement method of melting properties. 2. NF P92-505 Dripping test with electrical ... |
 |
Mask synthetic blood penetration tester | Standards: GB 19083-2010 Technical requirements of medical face masks - Anti-penetration property of 5.5 synthetic blood. YY/T 0691-2008 Clothin... |
 |
Seat Ingress/Egress Simulation Tester | Standard ISO 16840(Wheelchair Seating - Test Methods for Determining Mechanical Properties) FMVSS 207(Federal Motor Vehicle Safety Standard for S... |
Same products
 |
Thrust Bearing Rolling Friction and Wear Testing Machine | Seller: Standard International Group (HK) Limited | Applicable Standards: ASTM D3702 ASTM G99 ASTM G77 ISO 18535 Product Advantages: Simulates ... |
 |
Falling Sand Abrasion Test machine | Seller: Standard International Group (HK) Limited | The sand abrasion tester is a specialized testing device used to evaluate the abrasion resistance... |
 |
Conveyor Belt Drum Friction Testing Machine | Seller: Standard International Group (HK) Limited | Main Purposes of Conveyor Belt Drum Friction Testing Machine The conveyor belt drum friction tes... |
 |
Dry Sand Rubber Wheel Wear Tester | Seller: Standard International Group (HK) Limited | The dry sand rubber wheel abrasion tester is mainly used to test the abrasion resistance of mater... |
 |
Sliding Bearing Fatigue Testing Machine | Seller: Standard International Group (HK) Limited | The sliding bearing fatigue testing machine is an important testing device, mainly used to evalua... |
