Enameled Wire Stripping Machine

• 

Installation and use of enameled wire stripping machine.

Choose appropriate peeling wheel and install them on the machine. Put two enameled wire in the middle of the peeling wheels, set up two peeling wheels to clamp the enameled wire and gently hold the coil part with your hand then press the switch. To test the stripping effect, you can adjust the pressure between the two peeling wheels and control to achieve the ideal effect. When you start, put the enameled wire between two peeling wheels then pull out the wire easily from the wheels. So the peeling work is completed. For when the machine works, high-speed peeling wheels will rub against the insulation and the oxides of the enameled wire. After being peeled, the surface is shiny clean. When the surface of the nylon fiber peeling wheel is uneven or bump, it can cause disconnection or dirty peeling wheel. Fixing is required under this circumstances. You can use a cloth to smooth the wheel until the two strip wheel can smoothly contact. Regularly trim the peeling wheel and this will increase the life of the peeling wheel. When you need to replace the wheel, you can start the work again as long as you remove the wheel that you can no longer use, and then insert the new paint wheel. When we install wire stripping wheel, it should be noted that the wire wheel has direction.

Safety technical operation procedures.

1. When an abnormal situation occurs in the work, the power supply should be cut off immediately, and the concerned person should be asked to check and troubleshoot.
2. When scraping the enameled wire, it is necessary to prevent the enameled wire from being sucked into theenameledwire stripping machineand pay attention to the heat of the enameled wire.

3. Shut down the power supply when the enameled wire is not scratched.

Other supplier products

	BJ-940 Scrap Copper Wire Stripper Machine	Features of Scrap Copper Wire Stripper Machine BJ-940: This model wire stripping machine is both manually and electrically operated machine.Unde...
	BJ-02E 4 Drivers Wire Cutting Machine	Operation Video ofBJ-02E 4 Drivers Wire Cutting Machine Specification ofBJ-02E 4 DriversWire Cutting Machine Model: BJ-02E FOUR DRIVERS Powe...
	Pneumatic Terminal Crimping Machine	Pneumatic Terminal Crimping Machine Cable Hydraulic Crimping Machine BJ-30T * Force:20Ton* Applicable Scope:1-200mm² wire* Strok...
	Wire Stripping & Cutting Machine	Fully computer-controlled wire operation procedure This procedure is about the fully computer-controlled wire stripping & cutting machine op...
	RT-3000 PP Tape Dispenser	Specifications ofRT-3000 PP Tape Dispenser Available Width: 3 ~ 25mm Available Length: 9 ~ 61mm Power Supply: AC110V 60Hz / AC220V 50Hz Mea...

Same products

	Rail Welder A Frame aligners railway welding tools	Seller: 834406	产品描述 A型车架 A-Frame 是一种导轨对准器，可精确对准要焊接的导轨。该设备在焊接操作期间将导轨固定到位。
	2 parts fluid mixing dispenser 2 component dosing epoxy PU silicon rubber vacuum system	Seller: 824681	What is the difference between 2K AB adhesive materials manual potting machine and robot pottingm...
	Horizontal Machining Center	Seller: Xilong (Shanghai) Machine Tool Co., Ltd.	Horizontal Machining Center parts can automatically finish four sides milling, boring, drilling, ...
	Horizontal Lathe	Seller: Xilong (Shanghai) Machine Tool Co., Ltd.	As a professional horizontal lathe manufacturerand horizontal lathe factory, Sealion Machine Tool...
	Gantry Machining Center	Seller: Xilong (Shanghai) Machine Tool Co., Ltd.	SEALION supplies Gantry Machining Center both tables moving type or gantry moving type. Gantry ty...