Particle Abrasion meter
The Q-4D particle wear tester is specially designed as a standard instrument based on the national standard "Method for Determination of Wear Rate of Fertilizer Catalysts, Molecular Sieve, Adsorbent, etc." (GB3636-83), "3A Molecular Sieve" (GB, "4A Molecular Sieve" HG/2524-2011 "5A Molecular Sieve" (GB13550-92), "Test Method for Strength Determination of Wood Activated Carbon" (GB/T
Industrial Activated Alumina
HG/T3927-2007 and other test methods. It is a new generation of products launched after the Q-3 particle wear tester, with further improved performance and more reasonable structure. It is widely used in the determination of wear rate of catalysts, molecular sieves, adsorbents, alumina and other particle materials in the chemical, pharmaceutical, petroleum and other industries.
This instrument uses a single-chip microcomputer to control the stepper motor to drive the grinding drum to wear the material. Because of the single-chip control, its speed is accurate, the speed is uniform and stable, and the noise is low. The working status information of the instrument is indicated by LED light-emitting tube, which is clear and intuitive. In addition, it also has the functions of preset speed, setting alarm, setting pause, etc. The instrument has leading technology in China, reasonable structure, simple and intuitive operation, extremely stable and reliable performance, and extremely low failure rate. Therefore, it has a high performance-price ratio and is an ideal wear rate test device.
Main technical indicators
Speed: 25r/min, 30r/min, 40r/min, 50r/min, 60r/min, 80r/min, 100r/min can be set arbitrarily.
Counting range: 0~9999 r
Grinding cylinder inner size: Φ36x300mm; Φ50x300mm two each
Power supply: AC 220v±10% 50HZ
Send product request
Other supplier products
 |
Blow-By Test Rig，ISO 8178 internal combustion engine blow-by test system | Test system for the characterisation of the oil content in blow-by gases at engine test systems. The Blow-By Test System is a compact measuring sys... |
 |
Initial Adhesion Tester | The initial - tack tester, also known as the initial - tack property tester or adhesive tape tackiness tester, is an instrument specifically used t... |
 |
Leather thickness meter | Product Introduction Leather thickness tester is a special high-precision instrument for leather thickness measurement, which can be widely used f... |
 |
Single Wire Cable Burning Tester | The instrument is applicable to the test method and test requirementsof single insulated wire or cable combustion under the prescribed flame cond... |
 |
UV Aging Test Chamber 450 X 450 X 450mm , Programmable Ozone Test Chamber | Use of environmental test chamber Ozone Test chamberis used for testing rubber and polymer. Ozone aging test chamberis a major factor in rubber... |
Same products
 |
Plastic Smoke Density Tester F313 | Seller: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | Seller: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Seller: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Seller: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Seller: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
