Glove Cut Resistance Test meter
Product Introduction:
The machine is used to test the cutting resistance of gloves. Under the specified load, the blade cuts the sample to measure the cutting resistance of gloves. Widely used in fire research institute, fire gloves production enterprises, national quality inspection units.
Main technical parameters:
1. blade: stainless steel blade, hardness is not less than HRC45. the cutting edge length should not be less than 65mm, the width should not be less than 18mm, the thickness of (1.0±0.5)mm, the width of the blade bevel is (2.5±0.2)mm, the Angle of the cutting edge is 22°
2. weight bracket: the sum of its quality and blade quality should not be greater than 200g
3. Tool holder: The Angle between the blade plane and the long shaft of the sample fixture is (90+2)。 The Angle between the cutting edge and the short shaft of the sample fixture is (90+2)。
4. sample fixture: the surface of the arc type of metal fixture, arc radius of (38±05)mm, length should not be less than 110mm, width should not be less than 32mm
5. support frame: can ensure that the sample fixture at the specified rate along the direction of the blade edge
dynamic
6. sample size :50mmx50mm
7.Power supply :AC220V 50Hz 4kW
Meet the standard:
GB/T8965-2009 "Protective clothing flame retardant protection Part 1 Flame retardant clothing"
GA7-2004 Fire gloves
Send product request
Other supplier products
 |
Surface Flammability Tester丨Surface Flammability Test mechine | Standards 1. GB/T 8745-2001《textile Combustion performance fabric surface burning time measurement》 2. ISO 10047:1993《textile fabric surface burn... |
 |
Coatings Shear | Standard YY/T 0856-2011 (China): Specifies mechanical testing protocols for metal angular fixators, including single-compression bending and bendi... |
 |
Absorbable Bone - connecting Plates Four - point Bending Tester | Standard ASTM F2119: Standard test method for constant load testing of bioabsorbable screws and washers, applicable to bending performance evalu... |
 |
Horizontal/Vertical Flame Chamber UL 94 Chamber | Description: This machine is designed according to plastic Materials flammability test; It is used to test flammability, burning rate, flame spr... |
 |
Melt Index Tester | Standards： ISO 1133. ASTM D1238. GB/T 3682. JIS K7210 Main uses: The melt flow rate meter uses automatic sampling and balance weighing to determ... |
Same products
 |
Xenon Test Chamber | Seller: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Seller: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Seller: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Seller: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
 |
Flame retardant testing machine | Seller: Qinsun Instruments Co., LTD | Feature highlights: Flame Retardant Tester is designed for testing plastic runway surface layers... |
