Galvo Scanner
The single-axis galvo motor systemcontains a high-precision sensor and a motor part based on moving magnet technology. The motor rotor is optimized for excellent dynamic properties and response characteristics. In addition, the motor features high rigidity and low friction. Moreover, each motor is matched to a certain inertia mirror through the kinematics and dynamics simulation.
Types Of Galvanometer Scanner
Ultra-galvo Scanner
The single axis galvo scannerconsists of a galvanometer part based on moving magnet technology and a high precision sensor as a feedback part.
Extra-galvo scanner wiki
High precision miniature bearings bearing axial preloads ensure high rigidity and low friction operation, and special attention is paid to bearing life.
Analog Galvo Driver
Single driver board drives two galvanometers at the same time, cost-effective.
Digital Galvo Driver
Flexible use, unchanged hardware can match 10-30mm photoelectric galvanometer.
Galvoco2Scanner Wiki
The galvanometer parts of photoelectric analog xy galvanometerand grating digital galvanometer are similar, the biggest analog and digital system difference is using different encoders. The photoelectric analog galvanometer uses the photoelectric encoder. When the galvanometer drives the baffle to rotate, the area covered by the baffle will change, and the photocurrent generated will also change. Thus the corresponding relation between the photocurrent and the galvanometer deflection Angle is formed. Grating digital galvanometer uses grating encoder. When the galvanometer drives the grating size to rotate, Sin/Cos signals will be generated on the reading head. The phase of Sin/Cos signals are corresponding to the deflection Angle of the galvanometer.
How To Maintain My Laser Galvo ScannerWell
The repair and maintenance of all parts of this scanner head must be performed by Shenzhen Hans ScannerS&T CO., Ltd. Only Shenzhen Han's Scanner S&T CO., Ltd. has the correct test standards and correction system. The mirrors need to be regularly cleaned because the dirty mirrors would absorb the laser energy and interfere with the mirrors. Check the mirrors regularly, if they are dirty clean the laser galvo mirror as follows. Wearing a cotton glove, hold the edge of the mirrors, keep the optical emission surface face up and use clean compressed air to blow the mirrors to remove dust, dirt, etc. For storage, use, and service, please make sure: Storage temperature: -35°C to +60°C , Use temperature: 25°C ±10°C, Avoid damp or corrosion.
Отправить запрос, связаться с поставщиком
Другие товары поставщика
 |
5-axis Laser Micromachining System | 5-axis Laser MicromachiningSystem The ordinary precession drillingsystem can only process the taper hole, and can not achieve the standard strai... |
 |
Galvo Scanner | The single-axis galvo motor system contains a high-precision sensor and a motor part based on moving magnet technology. The motor rotor is optimize... |
 |
4-axis Large Field Processing System | The four-axis linkage system is mainly composed of XY galvanometers, XY motion platform, platform driver, GMC control card and general marking soft... |
 |
Laser Lens | Common Fθ lens is a series of general lens used in laserfields. The common F-theta lens has developed into the 3th generation product after e... |
 |
Laser Control Card | Laser Control Card GMC is a galvanometer motion control card independently developed by Shenzhen Han's Scanner S&T Co., LTD. GMC galvo control... |
