L06S20 professional fish type rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
FISH SNAKE CABLE PULLER 11 MM X 250MTS |
Technical Date of Fiberglass Duct Rodder Specification Rod Diameter (mm) Φ 4.5-Φ 16 Rod Length (m) 30m~500m Frame Spec. (mm) 1300x450x1330,... |
|
|
EP-510BH terminal crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
|
|
cable wire stripper |
1.tungsten steel blade,hard and sharp. 2.Can cut the smooth degree of slope. 3.For cutting out the standard of thick wide angle,diameter of the cab... |
|
|
Fish Tape Fiberglass Wire Cable Running Rod L0415 |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
BZ-85 electric battery power Cable Cutter |
Battery punch driver:BZ-85 Punching range:Dia 85mm(Cu/ Al cableand armoured cable) Punching force:60KN 1.All tools can be controlled by one key-pre... |
Все товары поставщика
Похожие товары
