L06S20 professional fish type rod
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
TC-100 manual cable cutting tool for AL cable |
Features: The handle is made of high tensive aluminum alloy, the knives are made by forging, long life span. Item No: TC-100 for cutting cable Cutt... |
|
|
YQ-1250 125 tons of hydraulic machine wire |
By tank, power establishment, reversing valve, pressure relief valve, oil pump body, pump oil institutions by the oil hole, high and low pressure o... |
|
|
cable drum jacks apply for Multiple wire disk specifications |
Cable jacks according to usage is also referred to as the cable bracket, wire shaft disc rack, cable bracket. The form can be divided into, hydraul... |
|
|
Cable bollard winch |
Powered winches are the construction tools of erecting electric circuits of high pressure electric transmission in the sky and laying eletrical cab... |
|
|
TC-38 hand tool for cutting cable |
Features: 1.Strong,light weight glass fiber handle. 2.Adjustable pivot bolt realized adjustable blade. 3.Changeable,forging blade heat treated and ... |
All supplier products
Same products
